Collets to suit your Makita Trimmer Router RT0700 (and variants eg C & CX), 3620 and RP0900.
Collet sizes 3.175mm, 4mm and 6mm have be specifically manufactured for Adam's Bits with a high degree of run out tolerance and then individually tested for centricity. This is one item were aftermarket performs better than genuine!
Available in (inner diameter)
- 3.175mm (1/8")
- 4mm
- 6mm
- 6.35mm (1/4")
- 8mm
- 9.53mm (3/8")
47 Reviews Hide Reviews Show Reviews
-
Makita collet 8mm
Works just fine
-
Router Collet 8mm for Makita RP0900
High quality, works perfectly. Very prompt delivery. Highly recommended seller!
-
COLLETS for MAKITA RT0700
I ordered / received 2 x Collets (4mm & 6mm) and they both fit perfectly in my Router. Very happy with my purchase. Thank you!
-
Collet
The collet range is much better now then that it was a yesr ago. From 1/8 to 1/2 inch and all the sizes in between! So far the collet holds up to the pushiment that all cnc programmers and operators put these components through. Adams Bits has been the best supplier of consumables!! Don't just take my word for it give them a go for yourself
-
Makita Collets
I received both collets. I found one (3.175) so tight that I could not insert the end mill. I contacted Adam about the issue, and it was replaced promptly without any bother. I would shop here again.
-
good service
good service
-
Makita Collet
Have yet to use it, However, I measured the collet's diameter, and it looks perfect.
-
collets
Very well made tolerances are bang on and good price. Fast delivery too.
-
Makita 6mm collet
Well made, solid, grips the bit snugly. For collets to work properly, accuracy in manufacture and the correct materials are very important and this product fits the bill.
