1 Flute DOWN CUT Carbide End Mill

$9.45 - $29.95
(9 reviews) Write a Review

1 Flute Down Cut

An 1 flute down cut are suitable for both aluminium composite material (a.k.a aluminium composite panel, ACM, alucobond), plastics and wood. Operating in the same manner as the 2 flute down cut, an 1 flute has a single cutting edge and forces chips back down into the material.

Suitable for

  • Plastics (ABS, acrylic, HPDE etc)
  • Aluminium Composite Materials

Adam’s Tips

Depending on the rigidity of your cnc, you can cut aluminium composite panel with 1 or 2 passes. Also, if you find that using a smaller diameter bit (e.g. 2mm) creates a higher than desired clean up time due to plastic chips packing back into the slot, try a 1 flute up cut for aluminium.

9 Reviews Hide Reviews Show Reviews

  • 5
    Bit

    Posted by Simi Timu on 15th May 2020

    Excellent n very clean

  • 5
    Fantastic

    Posted by James on 6th May 2020

    I know it's my first end mill, but it's great. Tested on MDF and it gives sharp, clean cuts all the way through.

  • 5
    OK on Aluminium

    Posted by Don on 7th Feb 2020

    Good value. Arrived fast. Works fine on Aluminium with no lube using shallow cuts and multiple passes. 2mm bit chatters if deeper cuts attempted. Probably better with lube, but I didn't want the mess on my hobby CNC Router.

  • 5
    1 FLUTE DOWN CUT CARBIDE END MILL

    Posted by Graham Duck on 19th Aug 2019

    I have used this end mill on MDF with a fairly high feed rate, the cutter performed well leaving a very clean cut. Highly recommend.

  • 4
    Down cut done the job with out excess chipping

    Posted by Michael Cook on 10th Jun 2019

    Job Aboriginal Art, engraving 3mm x3mm deep line and concentric circles with a space of 3mm between cut with cross hatching, it left the cross hatching areas cutting clean, on iron bark, slow but doing the job Thanks Michael

  • 5
    Single flute 6mm down cut carbide end mill

    Posted by Unknown on 18th Jul 2018

    Excellent results on soft pine. JL

  • 5
    Rob Seletto

    Posted by Rob Seletto on 17th May 2018

    Very happy with the clean top edge on plywood

  • 5
    1 flute down cut.

    Posted by Jorgen on 28th Mar 2018

    Have been using this bit to cut 3mm Aluca-panelling and 16mm Melamine
    Cutting had nice, clean edges with no burrs.

  • 5
    Excellent results in MDF

    Posted by Stephen Davies on 16th Jan 2018

    Have an Openbuilds C-beam DIY mill with a Bosch trim router as a spindle. Runs at 33,000 RPM.

    When cutting small parts found an uncut bit worked best for roughing and drilling holes. Got a perfect, clean edge when using this down cut bit for finishing.