Power Source Model EX40SD-M8M
Mechanised Torch Model FHT-EX®105RTXH
CNC Communication Plug can be found here
Simply to use / setup. Great power ratio. Mechanize or hand cutting.
SIMPLE OPERATION
- Plug & cut
- Engineered for hobbyist
HIGHEST APPLICATION FLEXIBILITY
- Plate thicknesses up to 15 mm +
- Lightweight, exceptionally portable
EX-TRA PERFORMANCE
- Precise cuts
- Easy operation
BEST COST-EFFECTIVENESS
- Very low investment
- Lower running costs

THERMACUT® EX-TRAFIRE® 40SD Manual Torch Manual Fact Sheet
Best for
- Hobby and light-workshop CNC plasma tables on 1 phase power
- Plate up to 15mm, with 8mm piercing on a 30–40A cut
- Machine or hand cutting, using the EX40SD-M8M mechanised torch
Not for
- Regular piercing of thicker plate or long production runs: the 100SD has 20mm piercing and an 80% duty cycle at 100A
- Sites without a suitable 1 phase supply and compressed air
Adam's Tip
The duty cycle is 40% at 40A, so on long cuts run a little below full current. Use the CNC communication plug so the table controller can start the arc and read the arc voltage.
Buying guide: Plasma Consumables Guide