Used in sign-making and detail work, V-bits are great for carving intricate design in detail on a wide range of materials. V-bits add depth and dimension where the same result cannot be achieved with a flat bit. These are a 1 flute cutter so the finish on softer material will leave a slight burr.
Suitable for
- Plastics (ABS, acrylic, HDPE etc.)
- Wood
- Soft Metals
Adam’s Tips
A V bit is a great alternative to a small diameter straight cutter in engraving very fine detail. Use a smaller degree bit with a finer tip to achieve width of cuts smaller than 0.5mm. It is advisable to test on some scrap your carve to dial in the desired result.
Best for
- Fine-detail engraving and small text in wood, acrylic, ABS, aluminium and brass
- Sign work needing very fine lines, with tips from 0.1mm and angles from 10° to 90°
- Replacing tiny flat cutters that break easily
Not for
- Deep V-carving: use a TCT V router bit or an insert V bit
- The cleanest finish in soft plastic: a 1 flute leaves a slight burr
Adam's Tip
Use a smaller angle with a 0.1mm tip for lines under 0.5mm wide. Test on scrap to dial in the depth.
Buying guide: V-Bit Angles Explained
Frequently asked questions
What is a 1 flute V bit used for?
Fine-detail engraving and sign work. It is a sharper alternative to a tiny flat cutter and can cut lines narrower than 0.5mm.
Which angle and tip should I choose?
Angles run from 10° to 90° with 0.1mm or 0.3mm tip flats. A smaller angle with a finer tip cuts narrower lines; a wider angle cuts broader, shallower V grooves.
What materials can it engrave?
Hardwood, softwood, MDF / HDF, acrylic, ABS, aluminium and brass. Being single flute, it can leave a slight burr in softer materials.
Any tips before the real job?
Test the carve on scrap first to dial in depth and line width.
30 Reviews Hide Reviews Show Reviews
-
1 FLUTE V BIT CARBIDE ENGRAVING BIT
At the Men's Shed we use this bit a great deal for engraving lettering, using our CNC router, in soft and hard wood, plastic, brass and aluminium. We run it at about 20000 RPM, with a depth of cut from 0.5 to 1.5 mm. It seems a good angle (30°) to get depth at the right width of cut.
-
1 FLUTE V BIT CARBIDE ENGRAVING BIT
This bit performed well, good value for money. Including recommended feeds and speeds and DOC would be helpful as a starting point, as the tip will snap off if you get it wrong to start with.
-
V Bit for the win
As with all of Adam's bits, the V bit is super durable and carves through timber like butter, achieving perfect fine detail. very happy
-
very good
love all the bits just starting with Adams bits but love them
-
1 F V bite for engraving
Really love these bits. I am new to using the 10 degree & really love the fine detail that can be achieved
-
Detail like a jeweller
Details perfectly in hard stock
-
Adams Bits
Very happy with my engraving bits and the service
-
great
great service Thank You
-
2 Flute V Bits
Best bits by far. Tried all the eBay bits and they don't come close to Adams Bits.
