A favourite of CNC enthusiasts is to 3D carve and a ball nose router bit allows you to do just that. These are a great entry level bits as the are value for money compared to tapered ball nose. The radius = 1/2 of the diameter with no flat bottom. These bits can also be used to engrave lettering.
Suitable for
- Plastics (ABS, acrylic, HPDE etc.)
- Wood (MDF, hardwood)
- Wood (Ply & softwoods)
Adam’s Tips
Cutting against the grain reduces fuzzy material forming in your carve. This can be set in your 3D carving software under the term "raster".
29 Reviews Hide Reviews Show Reviews
-
R1 ball end mill
Super sharp and clean cut on fine detail. Be careful with your gcode and settings because of the size, they can easily snap
-
End mill
Excellent product shipping very quick will buy again.
-
0.75 tapered ball mill
Quality tapered ball mill that delivers excellent cut quality, clean finish cutting 2mm deep into MDF on a single pass
-
2 Flute BALL NOSE Carbide Mill (for 3D Carving)
i use this bit to carve 3d relief's, does a great job.
-
Great with ply!
Clean and accurate! Using this end mill will probably reduce my finishing time by about 90% and that's a conservative estimate!
-
Adams Bits
Great quality, fantastic customer service, can highly recommend Adams Bits
-
Yet to be run.
Still waiting to run the cutters. Expecting this cutter to produce very nice results.
-
starting out
not used yet
-
2 FLUTE BALL NOSE CARBIDE MILL (FOR 3D CARVING)
I received the R3, This bit gives an excellent finish and is great value for money. Another quality bit from Adam's Bits
