Replacement straight torch body for the IPTM80 / PT80 machine plasma torch. The body is the part that takes the knocks on a CNC table: a crash, a tipped-up offcut or simply years of arc starts will eventually damage the head or the internal contacts. Swapping the body rather than the whole torch and lead keeps the repair cheap.
Straight Main Body for IPTM80
Also known as: PT80 PT-80 IPT80
PT-80 straight torch main body only
Specifications
- Current:80Amp
- Duty cycle: 60%
- Gas: Air/N₂
- Gas pressure: 4.5-5.0 Bar
- Gas flow: 110LPM
- Ignition: Pilot Arc
- Post flow: 80 sec.recommended
Fits the IPTM80 torch we supply and other PT80 pattern straight torches. Uses SC80/PT80 electrodes.
Stocked in our Laverton North (Melbourne) warehouse and shipped Australia-wide. Standard shipping is free on orders over $200.
Best for
- Repairing an IPTM80 / PT80 straight machine torch after a crash or worn contacts
- Avoiding the cost of replacing the whole torch and lead
Not for
- Hand torches or PT60 torches
Adam's Tip
Fit a collision-detecting torch holder to protect the new body. Replace the consumables at the same time, since a crash usually damages them too.
Buying guide: Plasma Consumables Guide
